SC22/WG20 N926 From: Matthew Deane [mdeane@ANSI.org] Sent: Thursday, January 17, 2002 6:40 PM Subject: TR 10176 Keld, In response to your e-mail message, the process to update the table in TR 10176 can occur in one of the following ways: 1. Revision of TR 10176 You are correct that a revision to a standard does not require an NP ballot. The Directives state the following: 6.2.1.5 The procedure of distributing the NP form for voting is not required in the case of revision of a published IS. Such revisions should, however, be recorded in JTC 1's programme of work as items at Stage 2 (see 12.1) and should have target dates and priorities assigned as for other work items. The downside to this option is that the entire text must be reviewed as the revision would be of the entire document (Unless it was agreed that no other part would be discussed. I don't know of WG20's experience with past revisions.) 2. Amendment to the TR This is an option that JTC 1 now offers. The amendment could simply be the updated table. This would require an NP ballot, but it could include the text along with the ballot and eliminate some ballot steps. If we pursue this option, I will examine further to see that best way to eliminate delays and extra ballot steps. It will be up to WG 20 to agree on the best way to move forward. The SC 22 resolution used the word revision, but it also targeted the one table, so I don't think the amendment approach would be out of line if it is easier. I have copied Arnold as there is some information included in this message that was not part of our phone conversation on this item. Best regards, Matt